Basic safety requirements for winding machines

Basic safety requirements for winding machines

1. The PPE of the operator must be fully dressed before operating.

2. The on-site mechanical operating shed shall be set up firmly to prevent heavy rain and wind.

3. It is prohibited to remove or move all kinds of protective devices, safety signs of protective facilities, fire-fighting equipment and electrical equipment.

4 in the processing of steel reinforcement should always pay attention to steel fracture, rebound injury. Manual transportation of steel bars do not hurt pedestrians is strictly prohibited to push and pull, should be in step, gently handle.

5. Before the equipment enters the site, it shall systematically check whether the mechanical equipment can operate normally and whether the protective facilities of the mechanical equipment are complete. The equipment can enter the site for use only after being accepted by the equipment department.

6. Onsite power cables should be connected by two or more electricians. Wear insulation shoes and gloves and use insulation tools according to regulations. Electric steel cage winding machine equipment, should be well insulated and grounded, each machine must be a machine a gate, and set leakage protection switch. The protection grounding should be less than 4 ohms, and the lightning protection grounding should be less than 10 ohms. Check and test the reliability. The exposed part of mechanical rotation shall be equipped with safety cover, and the power supply shall be disconnected when the work stops.